Pioneer DV-F727 Operating Instructions Manual page 58

To confirm the contents of a program
1 Press PROGRAM.
2 Use PREVIOUS 4 or NEXT ¢ buttons to jump to
the next/previous page of six steps (4/¢ on the
front panel cannot be used to perform this operation).
3 Press PROGRAM to exit the program screen.
To change the contents of a program
1 Press PROGRAM.
2 Jump to the page of steps with the contents you want
to change using the 4/¢ buttons (4/¢ on the
front panel cannot be used to perform this operation).
3 Move the cursor control joystick up or down to select
the step you want to change.
4 Move the cursor control joystick right or left to select
the appropriate field.
5 Press the number button(s) of the number you want
to change.
6 Press PROGRAM to exit the program screen.
To add to a program
Add a new Disc, Title/Track or Chapter at the end of the
program by following the steps in the section
"Programming" on the previous page.
To repeat the contents of a program
During program playback, press REPEAT. The entire
program will be repeated.
To delete a step in a program
1 Press PROGRAM.
2 Jump to the page with the contents you want to
delete using the 4/¢ buttons (4/¢ on the
front panel cannot be used to perform this operation).
3 Move the cursor control joystick up or down to select
the step you want to delete.
4 Press CLEAR.
5 Press PROGRAM to exit the program screen.
To clear the entire program
Pressing CLEAR when the disc is stopped will clear all
program data.
To stop program play
Press STOP 7.
58
Notes
• If a chapter is programmed for a disc that has not yet been
read by the player ("???" is displayed), and a CD or Video CD is
later detected in that disc position, the chapter program
information is cleared. Additionally, if there is no disc in the
selected disc position, or if the programmed chapter number is
larger than the number of chapters in the selected title, the
chapter program information is erased.
• During DVD playback, when a chapter that cannot be played as
part of program playback is encountered,
displayed, and the program automatically proceeds to the next
chapter.
• Programming is not possible during PBC playback of Video
CDs. To program Video CDs, stop playback before attempting
to make a program.
• During programmed playback, if the rack is rotated to play a
DVD, an asterisk may be displayed in the upper right corner of
the screen. This is to indicate that there is information on the
disc that must be played first (First Play PGC). Depending on
the disc, the asterisk may blink continuously during playback of
chapters that were not programmed and then disappear shortly
before playback of the desired location on the disc.
or is