Setting The Osd Language - Pioneer DV-F727 Operating Instructions Manual

Setting the OSD Language

(On-Screen Display Language)
The [OSD Language] screen establishes the OSD
language, or on-screen display language, which refers to
the language that is used by the player in menus and
on-screen messages. Additionally, the language that is
established at this setting will also be set as the audio
and subtitle language.
Audio1 2 Video Language
Setup Navigator
Language
OSD Language
Setup player's OSD language
Move
ENTER
Settings: English*
français
Español
Note
In addition to setting the OSD language, the audio and subtitle
language are also set at this time. If you wish to change the
audio or subtitle language to a different language, make changes
in the Setup screen Language menu [Audio Language] and
[Subtitle Language] as needed (page 46).
Setting the TV screen size
The [TV Connection] screen establishes the size, or
more appropriately, the width to height ratio of your
television or monitor. The width-to-height ratio of
conventional TVs is 4:3, while the width-to-height ratio of
wide screen and high-definition TVs is 16:9. This width-
to-height ratio is called the aspect ratio.
Audio1 2 Video Language
Setup Navigator
TV Connection
TV Type
Widescreen TV
16:9 aspect ratio
Move
ENTER
Settings: Widescreen (16:9)*
Standard (4:3)
Notes
• There are two screen formats that can be used to display
wide-screen format DVDs: letter box and pan & scan. When
"Standard (4:3)" is selected in the Setup Navigator, the letter
box screen format is automatically selected. To switch the
preference to the pan & scan format, make changes in the
Setup screen Video menu [TV Screen] setting (page 43).
• When "Standard (4:3)" is selected in the Setup Navigator,
Linear PCM digital audio playback is output is automatically
downsampled to 48 kHz (when the original signal is 96 kHz). In
order to hear audio at the sampling rate of 96 kHz, set the
Setup screen Video menu [TV Screen] setting to either
"Wide" or "4:3 (Pan & Scan)" (page 43). Additionally, make
sure that your system is set up to output the 96 kHz bitstream
using either the Setup Navigator or the Setup screen Audio 1
menu [96kHz PCM Out] setting (this page and page 41
respectively).
General
English
français
Español
Select Exit
SETUP
* Factory setting
General
Widescreen (16:9)
Standard (4:3)
Select Exit
SETUP
* Factory setting
Setting digital audio connections
to an AV amplifier or decoder
The [Digital Jacks] screen establishes what kind of digital
connections have been made to an AV amplifier,
receiver, or external decoder. Please refer to the
instructions supplied with the component the player is
connected to to determine what digital audio formats
can be decoded. If you have made no digital
connections, select "Not Connected".
Audio1 2 Video Language
Setup Navigator
Amp Connection
Digital Jacks
Compatible with Dolby Digital
Move
ENTER
Settings: Dolby Digital*
Select if the connected AV component is
capable of decoding the Dolby Digital
bitstream.
Dolby Digital/DTS
Select if the connected AV component is
capable of decoding Dolby Digital and DTS
bitstreams.
Dolby Digital/MPEG
Select if the connected AV component is
capable of decoding Dolby Digital and MPEG
bitstreams.
Dolby D/DTS/MPEG
Select if the connected AV component is
capable of decoding Dolby Digital, DTS, and
MPEG bitstreams.
PCM
Select if the connected AV component has
digital input jacks but no internal decoder.
Not Connected
No digital audio connections have been made.
General
Dolby Digital
Dolby Digital/DTS
Dolby Digital/MPEG
Dolby D/DTS/MPEG
PCM
Not Connected
Select Exit
SETUP
* Factory setting
21