Turning The Digital Output On And Off; Adjusting The Osd (On-Screen Display) - Pioneer DV-F727 Operating Instructions Manual

Turning the Digital Output On
and Off
Expert
Depending on your preferences and the type of
connections made, you may opt not to have the digital
audio signal output at all. When this setting is set to
"Off" there is no signal output from the digital audio
output jacks.
Make changes to the [Digital Out] setting in the Setup screen
Audio 1 menu in the "Expert" menu mode (page 40).
Audio1 2
Dolby Digital Out –
96kHz PCM Out – 96kHz>48kHz
Settings: On* (Digital bitstream is output.)
Off (Digital bitstream is not output.)
Adjusting the OSD (On-Screen
Display)
If you have already completed the Setup Navigator
screen operations, the settings on this page have
already been set by the player.
Setting the on-screen display
(OSD) language
This setting is used to establish the language that
operation indicators and on-screen messages and
operations display. Change this setting in the Setup
screen Language menu [OSD Language] setting.
Audio1 2
OSD Language English
Audio Language - English
Subtitle Language - Japanese
Auto Language – On
Setup player's OSD language
Settings: English*
français
Español
Note
The [OSD Language] setting is factory set to "English". If you
want English to be displayed, it is not necessary to adjust this
setting.
42
Video Language General
Dolby Digital
DTS Out – Off
MPEG Out – MPEG 3 PCM
Digital Out On
Off
Move Exit
SETUP
* Factory Setting
Video Language General
English
français
Español
Move Exit
SETUP
* Factory Setting
Turning the on-screen display on
or off
Expert
If you would rather not have the operation indicators
(Play, Stop, Resume, etc.) and other messages displayed
on the screen, it is possible to turn them off in the [On
Screen Display] setting in the Setup screen Video menu
in the "Expert" menu mode (page 40).
Audio1 2 Video Language
TV Screen –
Still Picture –
On Screen Display
OSD Position - Normal
Angle Indicator – On
Move
Settings: On*
Off
Setting the position of the
on-screen display
When watching conventional software on a wide screen
TV, the operation display is at the very top of the screen,
and may be difficult to see. Changing the position of the
display lets you see operation indicators clearly even on
a wide screen TV.
Make changes in the [OSD Position] in the Setup screen
Video menu in the "Expert" menu mode (page 40).
Audio1 2 Video Language
TV Screen –
Still Picture –
On Screen Display – On
OSD Position
Angle Indicator-
Move
Settings: Wide
Normal*
Note
This setting is only effective with DVDs that contain a 4:3 aspect
ratio video presentation.
General
16:9(Wide)
Field
On
Off
SETUP Exit
* Factory Setting
Expert
General
16:9(Wide)
Auto
Wide
Normal
Exit
SETUP
* Factory Setting