Verizon Fios-G2100 User Manual page 20

SETTING UP YOUR
FIOS ROUTER
Warning:
cable when the cable is removed from the connector. Avoid
direct exposure to the laser beam.
Important:
status of the rear LEDs (refer to section 11.0h). Please wait until
the Unified Button light on the front of the Fios Router stops
flashing and is solid white. If the light turns red, check the steps
in the Troubleshooting section of this user guide.
2.0b/ STEP 2 - CONNECT THE DEVICE TO YOUR FIOS
ROUTER
If connecting a device using Ethernet (preferred for initial setup):
•
Plug one end of the Ethernet cable into one of the four yellow
Ethernet ports in the back of your Fios Router. Alternatively, you
can use your own Ethernet cable of any color to connect from
the yellow Ethernet ports on the back of your Fios Router to your
device with an Ethernet connector.
•
Plug the other end of the yellow Ethernet cable into the Ethernet
port of your network device.
If connecting a wireless device:
•
Access the Wi-Fi setting on your wireless device, then select
your new Fios Router using the wireless network name (ESSID)
shown on the sticker located
on the rear of your Fios Router.
•
Enter the wireless password
(WPA2 key) also shown on the
sticker.
An invisible laser light may be present at the fiber optic
Before proceeding to section 2.0b, please check the