Preparing Media; Bluetooth - Panasonic SC-HC295 Owner's Manual

SC-HC295 PP TQBJ2048 En.Sp.fm Page 7 Wednesday, February 22, 2017 3:14 PM

Preparing media

Disc
1
Press [USB/CD] to select "CD".
2
Press [CD x] (main unit: [x OPEN/CLOSE]) to
open the sliding door.
Put in a disc with the label facing towards you.
3
Press [CD x] (main unit: [x OPEN/CLOSE]) again
to close the sliding door.
Keep fingers away from the sliding door when it is
closing.
USB
USB device
(not supplied)
Press [USB/CD] to select "USB".
Note:
Do not use a USB extension cable. The system cannot
recognize USB device connected through a cable.

Bluetooth

®
You can connect and play an audio device wirelessly
through Bluetooth .
®
Preparation
• Turn on the Bluetooth ® feature of the device and put
the device near the system.
• Read the operating instructions of the device for
details.
█
Pairing a device
Preparation
If this system is connected to a Bluetooth
disconnect it (Z"Disconnecting a device").
1
Press [ ] to select "BLUETOOTH".
If "PAIRING" is shown, continue with step 4.
Confidential
3 Mar 2017
Until:
2
Press [PLAY MENU] to select "PAIRING".
Or press and hold [
until "PAIRING" is shown. Continue with step 4.
3
Press [R, T] to select "OK? YES" and then press
[OK].
"PAIRING" is shown.
To cancel, select "OK? NO".
4
Select "SC-HC295" from the Bluetooth
the device.
If prompted for a passkey, input "0000".
The device connects with this system automatically
after pairing is complete.
The MAC address (e.g., 6C:5A:B5:B3:1D:0F) may be
shown before "SC-HC295" is shown.
The name of the connected device is shown for a few
seconds.
Note:
You can pair up to 8 devices with this system. If a 9th device
is paired, the device that has not been used for the longest
time will be replaced.
█
Connecting a device
Preparation
If this system is connected to a Bluetooth
disconnect it (Z"Disconnecting a device").
1
Press [
"BLUETOOTH READY" is shown.
2
Select "SC-HC295" from the Bluetooth
the device.
The name of the connected device is shown for a few
seconds.
3
Start playback on the device.
Note:
•
A device must be paired to connect.
•
This system can only connect to one device at a time.
• When "BLUETOOTH" is selected as the source, this
system will automatically try to connect to the last
connected device. ("LINKING" is shown during this
process.)
█
Disconnecting a device
1
Press [
2
Press [PLAY MENU] repeatedly to select
"DISCONNECT?".
3
Press [R, T] to select "OK? YES" and then press
[OK].
"BLUETOOTH READY" is shown.
To cancel, select "OK? NO".
Using the main unit
Press and hold [
shown.
Note:
® device,
A device is disconnected when you:
•
Select a different source.
•
Move the device out of the maximum range.
•
Disable the Bluetooth
• Turn off the system or the device.
final draft
–PAIRING] on the main unit
®
device,
®
] to select "BLUETOOTH".
®
] to select "BLUETOOTH".
–PAIRING] until "PAIRING" is
transmission of the device.
®
menu of
menu of
7