Remote Control Code - Panasonic SC-HC295 Owner's Manual

SC-HC295 PP TQBJ2048 En.Sp.fm Page 15 Wednesday, February 22, 2017 3:14 PM
█
Main unit displays
"--:--"
•
You connected the AC power supply cord for the first time
or there was a power failure recently. Set the clock.
•
Track play time is more than 99 minutes.
"ADJUST CLOCK"
• The clock is not set. Adjust the clock.
"ADJUST TIMER"
• The play timer is not set. Adjust the play timer.
"AUTO OFF"
•
The system has not been used for 20 minutes and will turn
off within a minute. To cancel, press any button.
"ERROR"
• An incorrect operation was done. Read the instructions and
try again.
"F61"
"F77"
•
Disconnect the AC power supply cord and consult your
dealer.
"F703"
•
Examine the Bluetooth ® connection.
•
Disconnect the Bluetooth device. Turn off the system and
®
then turn on again.
"F76"
• There is a problem with the power supply.
• Disconnect the AC power supply cord and consult your
dealer.
"ILLEGAL OPEN"
• The sliding door is not in a correct position. Turn off the
system and then turn on again.
"NODEVICE"
• The USB device is not connected. Examine the connection.
"NO DISC"
• You have not put in a disc.
"NO PLAY"
•
Examine the content. You can only play supported format.
• The system may have a problem. Turn off the system and
then turn on again.
"PLAYERROR"
• You played an unsupported MP3 file. The system will skip
that track and play the next one.
"REMOTE 1"
"REMOTE 2"
•
The remote control and the main unit are using different
codes. Change the code of the remote control.
–
When "REMOTE 1" is shown, press and hold [OK] and
[ ] for a minimum of 4 seconds.
– When "REMOTE 2" is shown, press and hold [OK] and
[USB/CD] for a minimum of 4 seconds.
"SOUND 1 NOT SET"
"SOUND 2 NOT SET"
"SOUND 3 NOT SET"
•
You have not saved the sound effects into the sound
setting number.
"USB OVER CURRENT ERROR"
• The USB device is using too much power. Disconnect the
USB device, turn off the system and then turn on again.
"VBR"
• The system cannot show the remaining play time for
variable bit rate (VBR) tracks.
Confidential
3 Mar 2017
Until:
final draft

Remote control code

When other Panasonic equipment responds to the
remote control of this system, change the remote control
code for this system.
Preparation
Press [USB/CD] to select "CD".
█
To set the code to "REMOTE 2"
1
Press and hold [SELECTOR] on the main unit and
[USB/CD] on the remote control.
"REMOTE 2" is shown.
2
Press and hold [OK] and [USB/CD] for a minimum
of 4 seconds.
█
To set the code to "REMOTE 1"
1
Press and hold [SELECTOR] on the main unit and
[ ] on the remote control.
"REMOTE 1" is shown.
2
Press and hold [OK] and [
4 seconds.
System memory reset
Reset the memory when the following situations occur:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
1
Disconnect the AC power supply cord.
2
While you press and hold [1] on the main unit,
connect the AC power supply cord again.
Continue to press and hold the button until
"– – – – – – – – –" is shown.
3
Release [1].
All the settings are set back to the factory preset.
It is necessary to set the memory items again.
] for a minimum of
15