Confirmation Of Indoor Unit No. Position - Toshiba RAV-SP1104AT8-E Service Manual

10-5. Confirmation of Indoor Unit No. Position

1. To know the indoor unit addresses though position of the indoor unit body is recognized
• In case of individual operation (Wired remote controller : indoor unit = 1 : 1)
(Follow to the procedure during operation)
<Procedure>
1
Push ON / OFF
2
Push UNIT LOUVER button.
1-1
Unit No. is displayed on LCD.
(It disappears after several seconds.)
The displayed unit No. indicate line address and
indoor unit address.
(When other indoor units are connected to the
identical remote controller (Group control unit), other
unit numbers are also displayed every pushing
button.
UNIT LOUVER
2. To know the position of indoor unit body by address
• To confirm the unit No. in the group control
(Follow to the procedure during operation) (in this procedure, the indoor units in group control stop.)
<Procedure>
The indoor unit numbers in the group control are
successively displayed, and fan, louver, and drain pump
of the corresponding indoor unit are turned on.
(Follow to the procedure during operation)
1
VENT
Push and
4 seconds or more.
• Unit No.
• Fans and louvers of all the indoor units in the
group control operate.
2
Every pushing
in the group control are successively displayed.
• The unit No. displayed at the first time indicates the
master unit address.
• Fan and louver of the selected indoor unit only
operate.
3
TEST
Push button to finish the procedure.
All the indoor units in the group control stop.
AMP Air Conditioning
button if the unit stops.
TEST
buttons simultaneously for
is displayed.
UNIT LOUVER button, the unit numbers
TEMP.
FILTER L L
RESET TEST
<Operation procedure>
1 2
END
TEMP.
1
FILTER L L
RESET TEST
3
<Operation procedure>
1 2
– 97 –
www.ampair.co.uk | sales@ampair.co.uk
ON / OFF
Operation
TIMER SET FAN MODE
TIME SAVE A A VENT
SET CL SWING/FIX UNIT LOUVER T
ON / OFF
TIMER SET FAN MODE
TIME SAVE A A VENT
SET CL SWING/FIX UNIT LOUVER T
3
END
1
2
2