Initial Setup; Adjusting Initial Settings; Switching The Auxiliary Setting; Setting The Rear Output And Subwoofer Controller - Pioneer Super Tuner III D AVH-P6850DVD Operation Manual

Section

Initial Setup

20

Adjusting initial settings

1
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1 Source icon
Shows which source has been selected.
2 Function display
Shows the function names.
1 Touch the source icon and then touch
OFF to turn this unit off.
# When the source icon is not displayed, you
can display it by touching the screen.
2 Touch AUDIO MENU and then touch
INITIAL to display the function names.
The function names are displayed and oper-
able ones are highlighted.
# To go to the next group of function names,
touch NEXT.
# To return to the previous group of function
names, touch PREV.
# To return to the previous display, touch BACK.
# To return to the display of each source, touch
ESC.
94
En
2
Black plate (94,1)

Switching the auxiliary setting

Auxiliary equipments connected to this unit
can be activated individually. Set each AUX
source to ON when using. About connecting
or using auxiliary equipments, refer to Using
the AUX source on page 101.
% Touch AUX1/AUX2 on the initial menu
to turn each auxiliary setting on.
# To turn auxiliary setting off, touch AUX1/
AUX2 again.
Setting the rear output and
subwoofer controller
This unit's rear output (rear speaker leads out-
put) can be used for full-range speaker (FULL)
or subwoofer (SUB. W) connection. If you
switch the rear output setting to SUB. W, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (FULL). When rear output is
connected to full range speakers (when FULL
is selected), you can connect the RCA sub-
woofer output to a subwoofer. In this case, you
can select whether to use the subwoofer con-
troller's (low pass filter, phase) built-in SUB.W
or the auxiliary FULL.
! When the multi-channel processor (e.g.,
DEQ-P7650/DEQ-P6600) is connected to
this unit, you cannot operate this function.
1 Touch REAR SP on the initial menu.
2 Touch c or d on the REAR SPEAKER to
switch the rear output setting.
Touch c to select full-range speaker and FULL
appears in the display. Touch d to select sub-
woofer and SUB. W appears in the display.
# When no subwoofer is connected to the rear
output, select FULL.
<CRB2163-B>94