Adjusting Loudness; Using Subwoofer Output; Using Nonfading Output - Pioneer Super Tuner III D AVH-P6850DVD Operation Manual

Section
Audio Adjustments
16
Note
If you make adjustments, Custom curve is up-
dated.

Adjusting loudness

Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Touch LOUDNESS on the audio function
menu.
2 Touch c on the LOUDNESS setting to
turn loudness on.
# To turn loudness off, touch d.
3 Touch c or d on the MODE setting to
select a desired level.
Each time you touch c or d selects level in
the following order:
LOW (low)—MID (mid)—HIGH (high)

Using subwoofer output

This unit is equipped with a subwoofer output
which can be turned on or off.
! When the subwoofer output is on, you can
adjust the cut-off frequency and the output
level of the subwoofer.
1 Touch SUB WOOFER on the audio func-
tion menu.
# When the PREOUT setting in the initial menu
is FULL, you cannot select SUB WOOFER.
2 Touch c on the SUBWOOFER setting to
turn subwoofer output on.
# To turn subwoofer output off, touch d.
3 Touch c or d on the PHASE setting to
select the phase of subwoofer output.
Touch d to select normal phase and
NORMAL appears in the display. Touch c to
72
En
Black plate (72,1)
select reverse phase and REVERSE appears in
the display.
4 Touch c or d on the LEVEL setting to
adjust the output level of the subwoofer.
Each time you touch c or d increases or de-
creases the level of the subwoofer. +6 to –6 is
displayed as the level is increased or de-
creased.
5 Touch c or d on the FREQUENCY set-
ting to select cut-off frequency.
Each time you touch c or d selects cut-off fre-
quencies in the following order:
50Hz—80Hz—125Hz
Only frequencies lower than those in the se-
lected range are outputted from the sub-
woofer.

Using nonfading output

When the nonfading output setting is on, the
audio signal does not pass through this unit's
low pass filter (for the subwoofer), but is out-
putted through the RCA output.
1 Touch NON FADING on the audio func-
tion menu.
# When the PREOUT setting in the initial menu
is only FULL, you can select NON FADING. (Refer
to page 94.)
2 Touch c on the NON FADING setting to
turn non fading output on.
# To turn non fading output off, touch d.
3 Touch c or d on the LEVEL setting to
adjust the output level of the non fading.
Each time you touch c or d increases or de-
creases the level of the non fading. +6 to –6 is
displayed as the level is increased or
decreased.
<CRB2163-B>72