Tv Tuner; Basic Operations; Storing And Recalling Broadcast Stations - Pioneer Premier DEH-P590IB Operation Manual

Section
03 Available accessories

TV tuner

Basic Operations

You can use this unit to control a TV tuner,
which is sold separately.
For details concerning operation, refer to the
TV tuner's operation manual. This section pro-
vides information on TV operations with this
unit which differs from that described in the
TV tuner's operation manual.
1 1 1 1
1 Band indicator
2 Preset number indicator
3 Channel indicator
1 Press SOURCE to select the TV.
2 Press BAND to select a band.
Press BAND until the desired band is dis-
played, TV-1 or TV-2.
3 To perform manual tuning, push
MULTI-CONTROL left or right.
4 To perform seek tuning, push and hold
MULTI-CONTROL left or right for about one
second and release.
The tuner will scan the channels until a broad-
cast strong enough for good reception is
found.
# You can cancel seek tuning by pushing
MULTI-CONTROL left or right.
# If you push and hold MULTI-CONTROL left or
right, you can skip broadcasting channels. Seek
tuning starts as soon as you release
MULTI-CONTROL.
56
En
Storing and recalling broadcast
stations
You can easily store up to 12 broadcast sta-
tions for later recall.
! Up to 24 stations, 12 for each of two TV
bands, can be stored in memory.
1 When you find a station that you want
to store in memory press LIST.
2 Use MULTI-CONTROL to store the se-
2 2 2 2
lected station in memory.
Turn to change the preset number; press and
hold to store.
The preset number you have selected will
flash and then remain lit. The selected station
has been stored in memory.
3 3 3
3 Use MULTI-CONTROL to select the de-
sired station.
Turn to change the station; press to select.
# You can also change the station by pushing
MULTI-CONTROL up or down.
# If you do not operate the list within about 30
seconds, the display is automatically returned to
the ordinary display.
Using the remote control
You can also store and recall stations assigned
to preset tuning numbers P.CH1 to P.CH6 by
using the remote control.
% When you find a station that you want
to store in memory, press one of preset
tuning buttons 1 to 6 and hold until the
preset number stops flashing.
The number you have pressed will flash in the
preset number indicator and then remain lit.
The selected station has been stored in mem-
ory.
The next time you press the same preset tun-
ing button the station is recalled from mem-
ory.
# You can also recall stations assigned to preset
tuning numbers by pushing MULTI-CONTROL up
or down during the channel display.