Use And Care Of The Remote Control; Menu Operations Identical For Function; Settings/Audio Adjustments/Initial Settings/Lists; Tuner - Pioneer DEH-P8300UB Owner's Manual

Operating this unit
Selecting a source
1 Press SRC/OFF to cycle between:
XM (XM tuner)—SIRIUS (SIRIUS tuner)—HD
Radio (HD Radio tuner)—TUNER (tuner)—CD
(CD player)—USB (USB storage device)/iPod
(iPod connected using USB input)—Pandora
(Pandora)—EXT (external unit 1)—EXT (exter-
nal unit 2)—AUX1 (AUX1)—AUX2 (AUX2)—
BT Audio (BT audio)—TEL (BT telephone)
Adjusting the volume
1 Turn M.C. to adjust the volume.
CAUTION
For safety reasons, park your vehicle when re-
moving the front panel.
Notes
! When this unit's blue/white lead is con-
nected to the vehicle's auto-antenna relay
control terminal, the vehicle's antenna ex-
tends when this unit's source is turned on.
To retract the antenna, turn the source off.
! If the HD Radio tuner is connected to this
unit, tuner source is skipped.
! If plug and play is on and either an iPhone or
iPod touch is connected, it may take time for
your source to switch. Refer to
USB plug&play (plug and play) on page 11.
Use and care of the remote
control
Using the remote control
1 Point the remote control in the direction of the
front panel to operate.
When using for the first time, pull out the film
protruding from the tray.
Replacing the battery
1 Slide the tray out on the back of the remote
control.
2 Insert the battery with the plus (+) and minus
(–) poles aligned properly.
WARNING
! Keep the battery out of the reach of children.
Should the battery be swallowed, consult a
doctor immediately.
! Batteries (battery pack or batteries installed)
must not be exposed to excessive heat such
as sunshine, fire or the like.
CAUTION
! Use one CR2025 (3 V) lithium battery.
! Remove the battery if the remote control is
not used for a month or longer.
! There is a danger of explosion if the battery is
incorrectly replaced. Replace only with the
same or equivalent type.
! Do not handle the battery with metallic tools.
! Do not store the battery with metallic ob-
jects.
! If the battery leaks, wipe the remote control
completely clean and install a new battery.
Operating this unit
! When disposing of used batteries, comply
with governmental regulations or environ-
mental public institutions' rules that apply in
your country/area.
! "Perchlorate Material – special handling may
apply.
See www.dtsc.ca.gov/hazardouswaste/
perchlorate. (Applicable to California,
U.S.A.)"
Important
! Do not store the remote control in high tem-
peratures or direct sunlight.
! The remote control may not function properly
in direct sunlight.
! Do not let the remote control fall onto the
floor, where it may become jammed under
the brake or accelerator pedal.
Menu operations identical
for function settings/audio
adjustments/initial settings/
lists
Returning to the previous display
Returning to the previous list/category (the folder/
category one level higher.)
1 Press DISP/
/SCRL.
Returning to the main menu
Returning to the top tier of the list/category.
1 Press and hold DISP/
/SCRL.
Returning to the ordinary display
Canceling the initial setting menu
1 Press BAND/ESC.
Returning to the ordinary display from the list/cat-
egory
1 Press BAND/ESC.

Tuner

Basic Operations
1 2 3 4 5 6 7
8
1 TAG indicator
2 Tags transferring indicator
3 Band indicator
4 5 (stereo) indicator
5 LOC indicator
Appears when local seek tuning is on.
6 Preset number indicator
7 Signal level indicator
8 Frequency indicator
Selecting a band
1 Press BAND/ESC until the desired band (FM-
1, FM-2, FM-3 for FM or AM) is displayed.
Manual tuning (step by step)
1 Push M.C. left or right.
Seeking
1 Push and hold M.C. left or right.
You can cancel seek tuning by pushing M.C.
left or right.
While pushing and holding M.C. left or right,
you can skip stations. Seek tuning starts as
soon as you release M.C.
Storing and recalling stations
for each band
1 Press (list).
The preset screen is displayed.
Section
02
5
En