Philips AVENT SCD630 User Manual page 27

HOW TO USE / CONNECTING THE UNITS
Where can I turn on the
nightlight?
How can I reset the
parent unit?
HOW TO USE / CONNECTING THE UNITS
Question
Where can I turn on the
nightlight?
INDICATIONS ON THE PARENT UNIT
Question
The battery LED on the
parent unit turns red.
What should I do?
Why does the parent
unit beep?
* VOX mode: The display and sound of the parent unit switch off if there is
no sound detected for 20 seconds (or not enough sound above the
sensitivity setting). Both display and sound will be activated immediately
when your baby cries and the sensitivity threshold is passed. When the
sound drops below the sound threshold, the video will remain active for 20
seconds. When one of the control buttons is pressed (brightness or
volume), the device shall display video for roughly 5 seconds. Also the
lullaby menu is accessible.
* ECO mode: The display and sound of the parent unit switch off when no
sound is detected for 20 seconds. Eco Mode reduces power consumption
during quiet times while keeping you connected to your baby. In ECO mode
the ECO LED light is green and the device will operate on a different
connection modus. In ECO mode the parent unit uses the 2 seconds ping
mechanism to check the connection with the baby unit instead of a
continuous radio frequency connection. Therefore the Baby Unit will also
consume less energy in ECO mode.
Press the nightlight on/off button on the baby unit to switch on the
nightlight feature. It is not possible to control the nightlight from the parent
unit. The nightlight does not turn off automatically, press the nightlight
on/off button again on the baby unit to switch it off.
You can reset the parent unit by simultaneously press the "power on/off
button" and the round "navigation down button" at the front of the parent
unit for about 1 second. The parent unit will switch off. In order to turn the
parent unit back on, press the "power on/off button". Specific user
information stored in the memory of the parent unit such as user mode,
brightness settings, volume, lullaby selection, zoom selection and vibration
settings will not be lost.
Answer
Press the nightlight on/off button on the baby unit to switch on the
nightlight feature. It is not possible to control the nightlight from the parent
unit. The nightlight does not turn off automatically, press the nightlight
on/off button again on the baby unit to switch it off.
Answer
The battery power is low. If you do not connect the parent unit to the mains
power when the battery LED has turned red and starts to make a beeping
sound, the unit will stop working after approximately 60 minutes.
Switch to lower brightness and/or volume to save battery consumption and
connect the parent unit to the mains with the power adapter. (see chapter
'Preparing for use').
Your baby monitor beeps in a certain way to tell you what the problem is.
27
English