Error Displays; When Requesting Repair - FUTABA 2HR Instruction Manual

Low Battery
When the LED starts blinking, replace the batteries immediately.
LED light:
Before requesting repair, read this instruction again and recheck your system. Should the
problems continue, request as follows.
(Information needed for repair)
Describe the problem in as much detail as possible and send the letter along with the
system in question.
• Symptom (Including the conditions and when the problem occurred)
• R/C System (Send transmitter, receiver and servos)
• Model (Type of model, brand name and model number or kit name)
• Detailed packing list (Make a list of all items sent in for repair)
• Your name, address and telephone number.
(Warranty)
Read the Warranty card.
• When requesting warranty service, send the card or some type of dated proof of
purchase.
Hobby Services (U.S. only)
Futaba Service Center
3002 N Apollo Drive Suite 1, Champaign, IL 61822 U.S.A.
TEL (217)398-8970 or E-mail: support@hobbico.com (Support)
TEL (217)398-0007 or E-mail: futabaservice@hobbico.com (Service)
FUTABA CORPORATION

Error Displays

Error Displays
WARNING
When a low battery alarm is generated, cease operation immediately
and retrieve the model. If the battery goes dead while in operation,
you will lose control.

When requesting repair

Phone: +81 475 32 6982, Facsimile: +81 475 32 6983
1080 Yabutsuka, Chosei-mura, Chosei-gun, Chiba-ken, 299-4395, Japan
©FUTABA CORPORATION 2015, 6
Reference
(1)
31