NETGEAR FWG114P Reference Manual page 32

Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P
R
ESTART YOUR NETWORK IN THE CORRECT SEQUENCE
2.
Warning: Failure to restart your network in the correct sequence could prevent you from
connecting to the Internet.
First, turn on the broadband modem and wait 2 minutes.
a.
Now, turn on your wireless firewall/print server.
b.
Last, turn on your computer.
c.
Note: If software usually logs you in to the Internet, do not run that software, or cancel it if
it starts automatically.
Broadband
PWR TEST
Power Test
Figure 3-4: Verify the connections to the firewall
Check the status lights and verify the following:
d.
• Power: The power light goes on when your turn the wireless firewall/print server on.
• Test: The test light turns on, then goes off after less than a minute.
• Local: A Local light on the router is lit. If no Local lights are lit, check that the
Ethernet cable connecting the powered on computer to the router is securely attached
at both ends.
• Internet: The Internet light on the wireless firewall/print server is lit. If the Internet
light is not lit, make sure the Ethernet cable is securely attached to the wireless
firewall/print server Internet port and the powered on modem.
3-6
ProSafe 802.11g Wireless Firewall/Print Server
MODEL
ACT ACT 100 100
1 2 3 4
ALERT LINK LNK/ACT LNK/ACT
P R IN TER M O DEM IN TER N ET LO CA L
Local Port 4
Internet Port
March 2004, 202-10027-01
FWG114P
W LA N
Connecting the FWG114P to the Internet