Aezk Uninstall / Install Cylinder Head - Kärcher K 6.200 Service Manual

AEZK Uninstall / install cylinder head

22
English 5.906-591.0 Rev. 00 (01/14)
 ADVR Uninstall / install valve for detergent
1 O rings
2 Water pipes
3 Safety clip
4 Holder capacitor
 Remove the pump motor from the chassis.
 Unhook the holder of the capacitor.
 Pull out the safety clip.
 Pull out the water pipes.
1 Screws
2 Valve gear casing
3 Cylinder head
4 Piston guide
5 O ring
6 Retaining clip
7 Pin
 Unscrew the screws.
 Carefully pull the holding clamps outwards.
 Remove valve gear casing with cylinder head.
 Remove the piston guide and the piston.
Note
Check O-rings for damage.
Clean the intake and sealing areas.
Pay attention to the correct fitting position during reinstal-
lation.
Torques
Screws
1 Cylinder head
2 O rings
3 Control valve
4 Injector nozzle
 Disconnect the cylinder head from the valve gear cas-
ing.
Note
Check O-rings for damage.
Clean the intake and sealing areas.
Check control valve and injector nozzle for ease of move-
ment, clean if necessary.
Pay attention to the correct fitting position during reinstal-
lation.
Nm
7,5...9,5