Table of Contents
Advertisement
3 Product description
3.4
Display operator control elements
1
1
m
button for selecting
the operating mode
(press briefly) / button
for selecting the priority
of a remote control
when there are several
remote controls (press
and hold)
3.4.1
Displayed symbols
Symbol
Meaning
Burner operating cor-
rectly
Water generation active
Ventilator active
Flow rate
Bath-filling mode
Normal operating mode
Prioritisation of the re-
mote controls
ECO mode
6
°C
L/min
3
2
2
and
button
3
button (on/off but-
ton)
Explanation
Burner on
Appears only when
water is flowing through
the product.
Appears when the ventil-
ator is running.
Appears in the bath-
filling mode.
Appears in the bath-
filling mode.
Appears in the normal
operating mode
The prioritised remote
control lights up on the
display, or the non-pri-
oritised remote controls
flash on the display.
Appears in ECO mode.
3.5
Control elements for further remote
controls (optional)
3
1
button (on/off but-
ton)
2
and
button
3.6
Recommended hot water temperature
settings
1
38 39 40 41 42 43 44 45 46 47 48 49
1
Washing dishes,
showering
The hot water temperature can be set from 38 ° C to 70 ° C
(default setting: 42 ° C ). If the water temperature that is set is
below 48 ° C before hot water generation begins, youcannot
increase the hot water temperature to above 48 ° C during
operation; this is to prevent scalding.
If the set water temperature was set to above 48 ° C before
hot water generation began , you can only reduce the tem-
perature during operation; this is to avoid scalding.
If the product is disconnected from the power mains and
started up again, the product reverts to the last hot water
temperature that was set, up to a maximum of 48 ° C.
If a hot water temperature of > 48 ° C has been set and no
hot water is drawn for 10 minutes , the hot water temperature
is automatically set to 48 ° C.
If several remote controls are used, the hot water temperat-
ure can only be set on the prioritised remote control.
3.6.1
Normal operating mode
The normal operating mode is used for hot water generation
with adjustable temperature. The normal operating mode is
activated after start-up.
3.6.2
ECO mode
ECO mode generates hot water at the temperature set be-
forehand and the water flow set beforehand.
Operating instructions turboMAG pro 0020208984_00
°C
2
1
3
Button for selecting the
priority for a remote
control
2
3
–
70
2
Showering, hot water
3
High temperature
Hide quick links:
Advertisement
Table of Contents
