Rerecording (Tape Duplication) 41; Playing - Philips VRZ360 Operator's Manual

VRZ360 4/7/99 9:53 PM
The instructions on this page show you how to copy tapes. The illustration uses two VCRs just like yours.
Different VCRs may operate differently. To duplicate a tape, make the connections shown, then follow
steps 1 - 6. (You may use the AUDIO and VIDEO In jacks on the front of VCR 2 instead if you prefer.)
VCR 1
Playing VCR
AUDIO
VIDEO
CH3 CH4
1) Use audio cables to
connect the AUDIO
OUT Jacks on VCR 1
to the AUDIO IN Jacks
on VCR 2.
1
VCR 1 will play your tape. Insert a prerecorded tape in VCR
1. If the tape does not have a record tab, playback begins. If this
happens, press the STOP/EJECT button on VCR 1 once.
2
VCR 2 will record your tape. Insert a blank tape in VCR 2.
Make sure the VCR power is on and the VCR is in VCR
position. (The VCR light will appear on the display panel. If it
does not, press the VCR/TV button once.)
3
Turn on the TV; set it to channel 3 or 4, whichever channel
the CH3/CH4 switch on VCR 2 is set to.
4
Point the remote control at VCR 2. Press the VCR but-
ton, then press the Number buttons 0, 0. L-1 will appear on
the display panel.
5
Point the remote control at VCR 2. Press the SPEED but-
ton to select SP or SLP.
6
Press the PLAY button on VCR 1 and the REC(ord)/OTR
button on VCR 2 at the same time. The \ light will appear
on the VCR 2 display panel.
Page 41
VCR 2
Recording VCR
IN IN OUT OUT
ANT.IN
R
L
RF OUT
audio cables
video cable

Rerecording (Tape Duplication) 41

3) Use an RF coaxial cable to connect the RF OUT
Jack on VCR 2 to the TV's ANTENNA IN Jack.
IN IN OUT OUT
ANT.IN
R
AUDIO
L
RF OUT
VIDEO
CH3 CH4
2) Use a video cable to
connect the VIDEO OUT
Jack on VCR 1 to the
VIDEO IN Jack on VCR 2.
Helpful Hints
• Unauthorized recording of copyright-
ed television programs, video tapes,
or other materials may infringe on
the rights of copyright owners and
violate copyright laws.
• Audio and video cables are not
included.
• To stop copying tapes, press the
STOP/EJECT button on VCR 2, then
press the STOP/EJECT button on
VCR 1.
• If you connect the audio and video
cables to the AUDIO/VIDEO In
jacks on the front of VCR 2, you
must select A/V IN FRONT at step
4. To do so, press Number buttons
0,0, then press the CH(annel) 9
button so that A/V IN FRONT
appears on-screen and L-F appears
on the display panel.