Secondary Menu - Stored Data - Graco 695 Operation Manual

Secondary Menu - Stored Data

1. Perform Pressure Relief, steps 1 - 4 if they have not
already been done.
2. Turn power switch on while holding DTS button down.
ti22881a
3. SERIAL NUMBER scrolls past and then serial number
(e.g. 00001) displays.
ti22720a
4. Short press DTS button and MOTOR HOURS scrolls past
and then total motor run hours are displayed.
5. Short press DTS button. LAST CODE scrolls by and last
code is displayed; e.g. E=07 (see Repair manual).
6. Press and hold DTS button to clear code to zero.
332916E
Digital Tracking System (ProContractor and IronMan models only)
7. Short press DTS button. W-DOG scrolls past then OFF
displays if watchdog switch is OFF. ON displays if Watch-
dog switch is ON.
8. Press and hold (8 seconds) DTS button to move to
WatchDog Trigger % menu. Continue to hold DTS button
and Watchdog can be set to trigger at 30, 40, 50, or 60%
of current sprayer pressure setting. Release DTS button
when desired % is displayed. Default is 50%.
9. Short press to move to SOFTWARE REV.
10. Short press DTS button. MOTOR ID RESISTOR scrolls
ti22721a
by and model code number (see below).
Motor ID Number
0
2
4
6
10
ti22722a
ti22723a
Models
695
795 / Mark IV
1095 / 230V Mark V
1595 / 120V Mark V / MARK VII
Mark X
ti22724a
ti22725a
21