Linefeed; Calibration Parameters - Fluke 7103 User Manual

serial interface will be immediately echoed or transmitted back to the device of origin.
With half duplex the commands will be executed but not ech oed. The duplex mode
parameter is indicated by,
The mode may be changed using "UP" or "DOWN" and pressing "SET".
9.8.2.4

Linefeed

The final parameter in the serial interface menu is the linefeed mode. This pa rameter
enables (on) or disables (off) transmission of a linefeed character (LF, ASCII 10) after
transmission of any carriage-return. The linefeed parameter is indicated by,
The mode may be changed using "UP" or "DOWN" and pressing "SET".
9.8.3

Calibration Parameters

The operator of the Micro-Bath controller has access to the Hard Cut-out and a
number of the bath calibration constants namely R0, ALPHA, DELTA, and BETA.
These values are set at the factory and should not be altered. The cor rect values are
important to the accuracy and proper and safe operation of the bath. Access to these
parameters is available to the user only so that in the event that the controller memory
fails the user may restore these values to the factory settings. The user should have a
list of these constants and their settings with manual.
Caution: DO NOT change the values of the bath calibration constants from the
factory set values. The correct setting of these parameters is im portant to the
safety and proper operation of the bath.
The calibration parameters menu is indicated by:
Press "SET" five times to enter the menu.
Shop for Fluke products online at:
Flashes "dUPL" and then displays the setting
dUPL
Current duplex mode setting
d=FULL
New duplex mode setting
d=HALF
Flashes "LF" and then displays the setting
LF
Current linefeed setting
LF= On
New linefeed setting
LF= OFF
Calibration parameters menu
CAL
MyFlukeStore
www.
Controller Operation
Controller Configuration
1.877.766.5412
.com
41