Table of Contents
Advertisement
Using the Transaxle: 10
Braking: 6
Selection of Ignition Modes
Press the engine switch to select the
"ACC" or "ON" mode as follows when you
use an electric accessory or check the
operation of instruments without running
the engine.
1) Bring the keyless push start system
remote controller with you and sit in the
driver's seat.
2) Without depressing the clutch pedal,
press the engine switch (1).
(1)
Every time you press the engine switch,
the ignition mode changes as follows.
(Audio equipment)
(OFF)
If the "PUSH" indicator light blinks and
the ignition modes cannot be selected
Your keyless push start system remote con-
troller may not be sensed as being within the
"interior workable area" (refer to the related
explanation in this section). Try again after
making sure you have the remote controller
with you. If the ignition modes still cannot be
selected, the battery of the remote controller
may be discharged. To be able to select an
ignition mode, you must then use the follow-
ing method:
EXAMPLE
82K254
(2)
1) Without depressing the brake pedal
and the clutch pedal, push the engine
switch (1).
2) Within about 10 seconds during which
the "PUSH" indicator light in the instru-
ment cluster is blinking, touch the
engine switch with the lock switch end
of the remote controller (2) for about 2
seconds.
74LHM0301
OPERATING YOUR VEHICLE
NOTE:
• If you still cannot select the ignition
modes, there may be some problem with
the keyless push start system. Contact
an authorized MARUTI SUZUKI dealer
for an inspection of the system.
• The immobilizer/keyless push start sys-
tem warning light come on for about 5
seconds while the "PUSH" indicator light
is blinking. Refer to "Warning and Indica-
tor Lights" in the "BEFORE DRIVING"
section for details.
• You may customize the system to cause
the interior buzzer to sound once for the
"remote controller out of sensing range"
warning. To incorporate this customiza-
(1)
tion, please contact an authorized MAR-
UTI SUZUKI dealer.
• If the battery of the remote controller is
about to become completely discharged,
the keyless push start system remote con-
troller battery consumption warning light in
the instrument cluster will come on for a
few seconds when you press the engine
switch to change the ignition mode to
"ON". Refer to "Warning and Indicator
Lights" in the "BEFORE DRIVING" section
57L21131
for details. For details on replacing the bat-
tery, refer to the "Keyless Push Start Sys-
tem Remote Controller" in the "BEFORE
DRIVING" section.
3-6
74LH0-74E
Advertisement
Table of Contents
