Programming Channel Control Lock - Universal Electronics Potenza ST Manual

PROGRAMMING MASTER POWER KEY
The Potenza ST Remote Control has a unique feature that allows you to sequentially turn up to
five of your home entertainment devices on or off with a single key press.
Note: The Master Power (POWER) only works in STB mode. If it is not programmed, only the
set-top box will turn on or off. In any other mode, pressing Master Power (POWER) once will
turn the selected device on or off.
Programming the Master Power Key
1. Press and hold SETUP key until the last device key blinks twice.
2. Enter 9 9 5 and release.
Note: The LED will blink 2 times after any three-digit programming sequence is entered correctly
3. Press POWER once.
4. Press device keys you want in the power sequence (STB, TV, AUD, DVD, VCR).
5. Press and hold SETUP key until the last device key blinks twice (3 seconds). To
play back the power sequence, press the POWER key while in STB mode.
Clearing the Master Power Key
1. Press and hold SETUP key until the last device key blinks twice.
2. Enter 9 9 5 and release.
Note: The LED will blink 2 times after any three-digit programming sequence is entered correctly
3. Press POWER key and release.
4. Press and hold SETUP key until the STB key blinks twice (3 seconds).

PROGRAMMING CHANNEL CONTROL LOCK

By default, the remote control's channel-control capabilities are not locked to the set-top box
mode However, you can activate the feature to lock these keys to the STB Mode. This will
.
guarantee you do not inadvertently change a channel on your TV or VCR.
The affected keys are 1 through 0, CH+, CH-, and LAST.
Locking Channel Control (to a Source Mode)
1. Press and hold SETUP key until it blinks twice.
2. Enter 9 7 3 and release.
Note: The LED will blink 2 times after any three-digit programming sequence is entered correctly.
3. Press the CH+ key and release.
4. Press the STB device key to lock channel control to the STB mode.
*Default channel control lock is in unlocked state.
Un-Locking Channel Control
1. Press and hold SETUP key until it blinks twice.
2. Enter 9 7 3 and release.
Note: The LED will blink 2 times after any three-digit programming sequence is entered correctly.
3. Press the CH- key and release.
*Default channel control lock is in unlocked state.