Replacing The Blade - Toro 20377 Operator's Manual

22in recycler lawn mower
Hide thumbs Also See for 20377:
Table of Contents

Advertisement

Important: If the oil level in the engine is too
low or too high and you run the engine, you may
damage the engine.
11. Install the dipstick securely.
12. Recycle the used oil properly.

Replacing the Blade

Service Interval: Yearly
Important: You will need a torque wrench to install the
blade properly . If you do not have a torque wrench or
are uncomfortable performing this procedure, contact
an Authorized Service Dealer.
Examine the blade whenever you run out of fuel. If the blade
is damaged or cracked, replace it immediately. If the blade
edge is dull or nicked, have it sharpened and balanced, or
replace it.
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Wear gloves when servicing the blade.
1. Refer to
Preparing for Maintenance (page
2. Tip the machine onto its side with the air filter up.
3. Use a block of wood to hold the blade steady
30).
4. Remove the blade, saving all mounting hardware
(Figure
30).
5. Install the new blade and all mounting hardware
(Figure
31).
14).
Figure 30
Important: Position the curved ends of the blade
to point toward the machine housing.
6. Use a torque wrench to tighten the blade bolt to
82 N∙m (60 ft-lb).
(Figure
Important: A bolt torqued to 82 N∙m (60 ft-lb) is
very tight. While holding the blade with a block
of wood, put your weight behind the ratchet or
wrench and tighten the bolt securely. This bolt is
very difficult to overtighten.
g005454
16
Figure 31
g005455

Advertisement

Table of Contents
loading

This manual is also suitable for:

20378

Table of Contents