Setup; Assembling And Unfolding The Handle - Toro 20377 Operator's Manual

132-4470
Traction Adjustment
1. Attention; read the
Operator's Manual—1)
Loosen the knob by turning
it counterclockwise; 2) Pull
the cable(s) away from
the engine to decrease
the traction, or push the
cable(s) toward the engine
to increase the traction;
3) Tighten the knob by
turning it clockwise.
decal132-4470
2. Scan the QR code for
more information on
traction adjustment.

Setup

Important: Remove and discard the protective plastic
sheet that covers the engine and any other plastic or
wrapping on the machine.
1
Assembling and Unfolding the
Handle
No Parts Required
Procedure
1. Remove and save the 2 handle knobs and 2 carriage
bolts from the handle brackets
1. Handle knob (2)
2. Install the handle ends onto the mower housing so that
the pin attached to each handle bracket is in the lower
hole of its related handle end
1. Handle end
4
(Figure 3).
Figure 3
2. Carriage bolt (2)
(Figure 4).
Figure 4
2. Pin
g189864
g189866