Table of Contents
Advertisement
Figure 20
5.
After draining the used oil, return the machine to
the operating position.
6.
Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
7.
Wait 3 minutes for the oil to settle in the engine.
8.
Wipe the dipstick clean with a clean cloth.
9.
Insert the dipstick into the oil-fill tube, screw it
in, then remove the dipstick.
10.
Read the oil level on the dipstick
•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
8
through
10
until the oil level on the dipstick
is correct.
•
If the oil level on the dipstick is too high,
drain the excess oil until the oil level on the
dipstick is correct.
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
11.
Install the dipstick into the oil-fill tube securely.
12.
Recycle the used oil properly.
Replacing the Blade
Service Interval: Yearly
Important:
install the blade properly. If you do not have a
torque wrench or are uncomfortable performing
this procedure, contact an Authorized Service
Dealer.
Examine the blade whenever you run out of fuel. If the
blade is damaged or cracked, replace it immediately.
If the blade edge is dull or nicked, have it sharpened
and balanced, or replace it.
g189232
The blade is sharp; contacting the blade can
result in serious personal injury.
Wear gloves when servicing the blade.
1.
2.
3.
(Figure
19).
4.
5.
19
You will need a torque wrench to
WARNING
Refer to
Preparing for Maintenance (page
Tip the machine onto its side with the air filter up.
Use a block of wood to hold the blade steady
(Figure
21).
Figure 21
Remove the blade, saving all mounting hardware
(Figure
21).
Install the new blade and all mounting hardware
(Figure
22).
17).
g231389
Advertisement
Table of Contents
