Using Multiple Controllers; Combining Universal And Deluxe Controllers - Rinnai MC-100V Operation And Installation Manual

Water controllers

Hide thumbs Also See for MC-100V:

Operation & installation manual (20 pages)

Table Of Contents

Table of Contents

DELUXE WATER CONTROLLERS

The voice prompt will say "The hot water system is

ready. Open the hot water tap". Open the hot water tap

for the relevant shower or bath.

The 'In Use' indicator

water controllers and the shower will run or the bath will

start to fill.

To Stop Shower Saver / Bath Fill Operation

If you wish to stop the water flow whilst the shower saver

/ bath fill function is in operation, simply press the

'Shower Saver / Bath fill'

The 'Shower Saver / Bath fill' button will flash and the

voice prompt will say "Hot water is not available, Turn off

all hot water taps and push the 'Bath fill' button". Follow

the voice prompt instructions.

When Shower Saver / Bath Fill Operations Finishes

Once the shower saver / bath fill operation finishes the

following events will occur:

1. The flow from the shower / bath hot water tap ceases.

2. The 'Shower Saver / Bath fill' button will flash.

3. The deluxe kitchen water controller 'Bath' indicator

will flash.

4. A tone will sound.

5. The voice prompt will say "Bath fill is complete. Turn

off the bath hot water tap and push the bath fill

button."

Follow the voice prompts instructions. Note that the water heater will not allow hot water to flow from

any fixture until the 'Shower Saver/ Bath fill'

6. The 'Shower Saver / Bath fill' button light on the Bathroom Controller and the 'Bath' indicator on the

deluxe kitchen water controller monitor (when fitted) will go out.

CHECK WATER TEMPERATURE BEFORE USE.

A parent or carer should always check the temperature before a child is placed

CAUTION

in contact with hot water.

NEVER LEAVE YOUNG CHILDREN UNATTENDED IN THE BATH.

When using the 'Shower saver / Bath fill' function, ALWAYS close the hot water

tap for the bath or shower after the flow has stopped.

Whilst hot water outlets are open the set temperature may be lowered. However

they cannot then be raised above 43°C. In addition transfer of 'priority' between

NOTE

controllers is not possible. These are safety features.