Deluxe Water Controllers; About The Deluxe Kitchen Water Controller (Mc-100V); How To Use The Deluxe Kitchen Water Controller (Mc-100V) - Rinnai MC-100V Operation And Installation Manual

DELUXE WATER CONTROLLERS

ABOUT THE DELUXE KITCHEN WATER CONTROLLER (MC-100V)

WATER TEMPERATURE
INDICATOR
Indicates the selected hot water
temperature.
WATER HEATER
'In Use' INDICATOR
Indicates that the water heater is in
operation and delivering hot water.
CLOCK
12 Hour AM / PM clock display.
In the event of a fault, codes for
error messages will flash here.
SPEAKER

HOW TO USE THE DELUXE KITCHEN WATER CONTROLLER (MC-100V)

Turning on the Controller
If the controller is switched off (No digits other than the clock digits
displayed in the digital monitor) press the On/Off button once.
The On/Off and Transfer buttons illuminate to indicate that the hot
water unit will be ready to supply hot water once a hot water tap is
opened.
If more than one controller is fitted press the 'Transfer'
transfer priority to the desired controller.
The MC-100V controller is not water resistant, avoid direct exposure to water or
steam as these conditions may cause damage.
NOTE
Setting The Clock
The clock is a 12 hour AM/PM style display. To set the time press the 'Mode'
places the controller into clock setting mode, in the digital monitor the word 'Clock' will be displayed
and the clock digits will flash, if this is the first time the clock has been set the starting time will be AM
12:00.
Use the or buttons to select the desired time, holding these buttons down continuously cycles
the digits. When you get close to the time you wish to set, press the button intermittently to avoid going
further than the desired time.
Rinnai New Zealand
SHOWER SAVER /
BATH FILL INDICATOR
Indicates that the Shower Saver /
Bath Fill function is operating.
ON/OFF BUTTON
Used to switch the water heater on and
off. This button is illuminated when the
hot water heating system is on.
2
DIGITAL
MONITOR
UP AND DOWN BUTTONS
W h e n i n N o r m a l m o d e t h e s e
buttons are used to select the
water temperature.
In 'Setup' mode these buttons are
used to adjust the voice prompt
volume and to set the clock.
MODE BUTTON
U s e d t o s w i t h t h e c o n t r o l l e r
between Normal, Voice or Clock
modes.
TRANSFER BUTTON
Used to transfer control priority
b e t w e e n t h e t e m p e r a t u r e
controllers. The controller with
priority has command of the hot
water delivery temperature. This
button is illuminated when this
controller has priority.
button to
button twice, this
Operation Manual:01-07