Remove The Mechanism Assembly; Remove The Module Board - JVC DR-M10SEF Service Manual

3.1.3 Remove the mechanism assembly (See figure 5)
• Prior to performing the following procedure, remove the top
cover.
• There is no need to remove the front panel assembly.
(1) Disconnect the socket wire from connector
power supply board.
(2) Disconnect the card wire from connector
module board.
(3) Remove the four screws C attaching the mechanism as-
sembly.
3.1.4 Remove the module board (See figure 6, figure 7)
• Prior to performing the following procedure, remove the top
cover.
(1) Disconnect the card wire from connector
module board.
(2) Remove the four screws D and E attaching the module
board.
(3) Remove the one screw F attaching the DV terminal board.
(4) Lift the module board up, and remove it. Then, the module
board is removed from the connectors CN4101,
on the main board. In attaching the module board, insert
the connector on the module board in these connectors se-
curely.
Module board
CN5303 on the
CN2201 on the
DV terminal
board
CN2201 on the
CN4102
D
D
Module board
Mechanism assembly
C
CN2201 C
Fig.5
F E
Module board E CN2201
Fig.6
CN4102
CN4101
Fig.7
C
C CN5303
Main board
(No.XA020)1-7