Super Io Configuration - Supermicro SUPERSERVER 5018D-FN8T User Manual

SuperServer 5018D-FN8T User's Manual
VGA Priority
This feature allows the user to select the graphics adapter to be used as the primary
boot device. The options are Onboard and Offboard.
Network Stack
Select Enabled enable PXE (Preboot Execution Environment) or UEFI (Unified
Extensible Firmware Interface) for network stack support. The options are Enabled
and Disabled.
*If "Network Stack" is set to Enabled, the four items below will become
available for configuration:
IPv4 PXE Support
Select Enabled to enable IPv4 PXE boot support. The options are Disabled and
Enabled.
IPv6 PXE Support
Select Enabled to enable IPv6 PXE boot support. The options are Disabled and
Enabled.
PXE boot wait time
Use this option to specify the wait time to press the ESC key to abort the PXE boot.
Press "+" or "-" on your keyboard to change the value. The default setting is 0.
Media detect count
Use this option to specify the number of times media will be checked. Press "+" or
"-" on your keyboard to change the value. The default setting is 1.
Super IO Configuration
Super IO Chip AST2400

Serial Port 1 Configuration
This submenu allows the user the configure settings of Serial Port 1 or Serial Port 2.
Serial Port
Select Enabled to enable the selected onboard serial port. The options are Disabled
and Enabled.
Device Settings
This item displays the status of a serial part specified by the user.
7-20