Table of Contents
Advertisement
Installation and Removal of the HT5F1800B
Transmitter Battery
Attachment of the battery
1. Slide the battery cover on the bottom of
the transmitter toward the right side and
open it.
① Push to open.
②Slide in the direction of the
arrow on the battery cover.
③ Battery cover will open downward.
2. Install the battery in the holder.
3. Connect the battery connector.
Battery
Connector
4. Close the battery cover completely.
22
<Before Use>
Battery
release tab
Battery Removal
Note: If you remove the battery while the
power is on, the data you have set will not
be saved.
1. Open the battery cover.
2. Disconnect the battery connector.
3. Press on the battery release tab and pull
the battery downwards to remove.
4. Close the battery cover completely.
Warning
Be careful not to drop the battery.
Never disconnect the battery connector
from the T14SG transmitter after
turning off the power until the screen is
completely blank and the transmitter has
shut down completely.
* Internal devices such as memories may be damaged.
* If there is any problem, the message "Backup Error"
will be shown the next time when you turn on the
power of the transmitter. Do not use the transmitter as
it is. Send it to the Futaba Service Center.
Advertisement
Table of Contents
