Cautions On Handling Antenna; Led Monitor - FUTABA 14SG Instruction Manual

14-channel computer system
Hide thumbs Also See for 14SG:
Table of Contents

Advertisement

Transmitter's Antenna:
As with all radio frequency transmissions,
the strongest area of signal transmission is from
the sides of the transmitter's antenna. As such,
the antenna should not be pointed directly at the
model. If your flying style creates this situation,
easily move the antenna to correct this situation.
•Rotating antenna
The antenna can be rotated 90 degrees and angled
90 degrees. Forcing the antenna further than this
can damage it. The antenna is not removable.
90°
90°
Low power
High power
If you have a transmitter
at an angle of a figure, an
antenna will be good to use
it, bending 90 degrees.
It is not good for there to
be a model on flight in the
direction tip of an antenna.
14
<Before Use>
Doing so may degrade the quality of the RF
There is the danger that the antenna wire will break
There is the danger that the antenna wire will break
Monitor LED display
LED at the bottom left and right sides of the
"T14SG" logo.
High power
LED (Left)
• Blinking
LED (Right)
transmission.
• Off
• On
• Blinking
Caution
Please do not grasp the transmitter's
antenna during flight.
transmission to the model
Do not carry the transmitter by the
antenna.
and operation will become impossible.
Do not pull the antenna forcefully.
and operation will become impossible.
The status of the transmitter is displayed by
Displays the "non-default condition" warning.
Power switch is turned on when any
condition switch is activated (in the ON
state).
D i s p l a y s t h e s t a t e o f r a d i o f r e q u e n c y
Radio waves are in the OFF state.
Radio waves are being transmitted.
Range check mode.

Advertisement

Table of Contents
loading

Table of Contents