Service Switches; Using The Device; Using The Multi-Card Reader - VeriFone UX300 Installation Manual

S
ETUP

Service Switches

Service
Switches

Using the Device

Using the Multi-Card
Reader
To conduct a card
transaction
24
UX300 M C
ANUAL ARD
7
Connect the other end of both ground installation cables to the nearest ground
installations, to complete the grounding of the UX300 and PIN pad units. See
(C) in Figure 11.
Figure 11 Grounding the UX300 and PIN Pad Units
There are three anti-removal service switches: two on the front of the card reader
(see Figure 1), and one on the back side of the unit (see
switches detect any unauthorized removal attempts and trigger a software event if
the unit is removed in an unauthorized manner. This does not cause any
hardware damage to the reader.
The card transaction procedure can vary depending on the application. Verify the
proper procedure with your application provider before performing a card
transaction.
The UX300 supports both magnetic stripe cards, as well as smart cards. The
following section describes how to use the device's multi-card reader.
The device's card reader supports both a triple-track card reader, as well as a
variety of smart cards.
1
Position the card, with the magnetic stripe facing downward and to the right of
the card, or with the chip on the top right of the card (see
2
Insert the card into the card reader slot in a smooth, continuous motion until it
seats firmly.
If using a magnetic card, proceed to
If using a smart card, proceed to
3
Remove the magnetic stripe card.
R I G
EADER NSTALLATION UIDE
A
C
Step 3.
Step 4.
B
C
Figure 3). These
Figure 12).