Alignment Position Adjustment Of The Alignment Plate - Canon Inner Finisher-H1 Service Manual

6. Fit the leading edge of the front alignment plate to paper, and confirm that a gap between the adjustment plate and
the paper are 1mm or less at [A] portion.
Front Alignment Plate
1.0 mm or less

Alignment Position Adjustment of the Alignment Plate

■ Adjustment procedure
1. Enter the following Service Mode.
• Adjustment of alignment position (A4):
SORTER > ADJUST > INF-ALG1
• Adjustment of alignment position (LTR):
SORTER > ADJUST > INF-ALG2
2. Enter the setting value -50 (switch negative/positive by -/+ key) and press OK key.
This operation stops the alignment plate at the current alignment position +5.0mm.
3. Set A4 or LTR paper on the processing tray unit.
4. Fit the paper [1] to the leading edge [2] of the rear alignment plate.
10 mm
81
5. Adjustment
Paper