Assigning A Profile To A Specific Lre Port; Assigning A Global Sequence To All Lre Ports - Cisco Catalyst 2950 Software Configuration Manual

Chapter 12 Configuring LRE

Assigning a Profile to a Specific LRE Port

You can set profiles on a per-port basis. You can assign the same profile or different profiles to the LRE
ports on the switch. The default active profile on all LRE ports is LRE-10 on the Catalyst 2950ST-8 LRE
and 2950ST-24 LRE switches and LRE-6 on the Catalyst 2950ST-24 LRE 997 switch.
The switch resets the ports with the updated profile settings when they are changed.
Beginning in privileged EXEC mode, follow these steps to assign a profile to a specific LRE port:
Command
Step 1 configure terminal
Step 2 interface interface-id
Step 3
profile profile-name
Step 4
end
Step 5 show controllers lre profile details
Step 6 copy running-config startup-config (Optional) Save your entries in the configuration file.
To delete the profile from a sequence, use the no profile profile-name interface configuration command.
To display the LRE link statistics and profile information on the LRE ports, use the show controllers
lre privileged EXEC command.

Assigning a Global Sequence to All LRE Ports

Global sequences are set on a switch-wide basis. If you assign a global sequence to the switch, it
overrides any previously or subsequently set profiles. For more information on sequence and profile
precendence, see the
Changes to the global sequence settings are immediately put in effect, and the global mode automatically
becomes the active mode.
Beginning in privileged EXEC mode, follow these steps to assign a global sequence to the LRE ports:
Command
Step 1 configure terminal
Step 2
lre rate selection sequence sequence-name Enter the global sequence name. Select from the list in
Step 3
end
Step 4 show controllers lre status sequence
Step 5 copy running-config startup-config
78-11380-12
Purpose
Enter global configuration mode.
Specify the LRE port to be configured, and enter interface configuration
mode.
Enter the port profile name (select from the list in
or Table 12-2 on page
Return to privileged EXEC mode.
Verify the change.
"Guidelines for Using LRE Profiles" section on page
Purpose
Enter global configuration mode.
page 12-5 and
Return to privileged EXEC mode.
Verify the change.
(Optional) Save your entries in the configuration file.
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
12-4).
Table 12-4 on page 12-6.
Configuring LRE Ports
Table 12-1 on page 12-3
12-10.
Table 12-3 on
12-13