Mapping Tables; Queueing And Scheduling; How Class Of Service Works; Port Priority - Cisco Catalyst 2950 Software Configuration Manual

Understanding QoS

Mapping Tables

Note This feature is available only if your switch is running the EI.
During classification, QoS uses a configurable CoS-to-DSCP map to derive an internal DSCP value from
the received CoS value. This DSCP value represents the priority of the traffic.
Before the traffic reaches the scheduling stage, QoS uses the configurable DSCP-to-CoS map to derive
a CoS value from the internal DSCP value. The CoS value is used to select one of the four egress queues.
The CoS-to-DSCP and DSCP-to-CoS maps have default values that might or might not be appropriate
for your network.
For configuration information, see the

Queueing and Scheduling

Both the SI and EI support this feature.
Note
The switch gives QoS-based IEEE 802.1p CoS values. QoS uses classification and scheduling to send
network traffic from the switch in a predictable manner. QoS classifies frames by assigning
priority-indexed CoS values to them and gives preference to higher-priority traffic such as telephone
calls.

How Class of Service Works

Before you set up IEEE 802.1p CoS on a Catalyst 2950 or Catalyst 2955 switch that operates with the
Catalyst 6000 family of switches, see the Catalyst 6000 documentation. There are differences in the
IEEE 802.1p implementation that you should understand to ensure compatibility.

Port Priority

Frames received from users in the administratively defined VLANs are classified or tagged for
transmission to other devices. Based on rules that you define, a unique identifier (the tag) is inserted in
each frame header before it is forwarded. The tag is examined and understood by each device before any
broadcasts or transmissions to other switches, routers, or end stations. When the frame reaches the last
switch or router, the tag is removed before the frame is sent to the target end station. VLANs that are
assigned on trunk or access ports without identification or a tag are called native or untagged frames.
For IEEE 802.1Q frames with tag information, the priority value from the header frame is used. For
native frames, the default priority of the input port is used.
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
29-8
"Configuring CoS Maps" section on page
Chapter 29 Configuring QoS
29-34.
78-11380-12