Reflector Port; Span Traffic - Cisco Catalyst 2950 Software Configuration Manual

Chapter 24 Configuring SPAN and RSPAN

Reflector Port

The reflector port is the mechanism that copies packets onto an RSPAN VLAN. The reflector port
forwards only the traffic from the RSPAN source session with which it is affiliated. Any device
connected to a port set as a reflector port loses connectivity until the RSPAN source session is disabled.
The reflector port has these characteristics:
•
•
•
•
•
•
•
•
•
If the bandwidth of the reflector port is not sufficient for the traffic volume from the corresponding
source ports, the excess packets are dropped. A 10/100 port reflects at 100 Mbps. A Gigabit port reflects
at 1 Gbps.

SPAN Traffic

You can use local SPAN to monitor all network traffic, including multicast and bridge protocol data unit
(BPDU) packets, and CDP, VTP, DTP, STP, PagP, and LACP packets. You cannot use RSPAN to monitor
Layer 2 protocols. See the
information.
In some SPAN configurations, multiple copies of the same source packet are sent to the SPAN
destination port. For example, a bidirectional (both Rx and Tx) SPAN session is configured for the
sources a1 Rx monitor and the a2 Rx and Tx monitor to destination port d1. If a packet enters the switch
through a1 and is switched to a2, both incoming and outgoing packets are sent to destination port d1.
78-11380-12
It is a port set to loopback.
It cannot be an EtherChannel group, it does not trunk, and it cannot do protocol filtering.
It can be a physical port that is assigned to an EtherChannel group, even if the EtherChannel group
is specified as a SPAN source. The port is removed from the group while it is configured as a
reflector port.
A port used as a reflector port cannot be a SPAN source or destination port, nor can a port be a
reflector port for more than one session at a time.
It is invisible to all VLANs.
The native VLAN for looped-back traffic on a reflector port is the RSPAN VLAN.
The reflector port loops back untagged traffic to the switch. The traffic is then placed on the RSPAN
VLAN and flooded to any trunk ports that carry the RSPAN VLAN.
Spanning tree is automatically disabled on a reflector port.
A reflector port receives copies of sent and received traffic for all monitored source ports. If a
reflector port is oversubscribed, it could become congested. This could affect traffic forwarding on
one or more of the source ports.
"RSPAN Configuration Guidelines" section on page 24-12
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
Understanding SPAN and RSPAN
for more
24-5