Table of Contents
Advertisement
Installation overview
Read these instructions to get an overview of the steps required before starting the
installation. Failure to follow these instructions could cause a malfunction of the
appliance. This could result in serious injury and/or property damage.
Unpack the appliance and components, and check for damage. Do not install any
damaged parts. Check all components have been supplied and that you have the
correct gas type.
Build the frame and
complete the electrical
connection.
Install ducting kit, if
purchased—separate
instruction.
Install cladding, refer
importantant note on p. 18.
10 | RDV3611 installation guide: 11156-E 05-16
Install mounting brackets,
the Symmetry unit, and fix
the unit to the frame.
Install flue restrictor (if req.)
and log set.
Install frames.
Install the flue and
complete the gas
connection.
Test pressures and establish
flame pattern.
Commission unit and
uprate if an LPG unit with a
vertical termination.
RDV3611 : SYMMETRY
Vertical Flue Up Rating Instructions (ULPG ONLY)
Must be installed by a certified gas fitter in accordance with all applicable local rules and regulations
The Rinnai Symmetry RDV3611 LPG appliance is factory supplied, with rated input of 30MJ/hr for
installation for Horizontal Vent Terminations only. To ensure that optimum Flame Effect and
Maximum Energy Efficiency is obtained when the unit is being installed with a Vertical Vent
Termination the appliance must be up rated to 33MJ/hr by installing this Kit.
Kit Contents
Quantity
Rinnai Part Number
Main Injector
1
11534
Data Plate
1
11152
Instruction Sheet
1
11154
Gas Up Rating Procedure
1. Remove Glass assembly 4 x screws; lift and remove.
2. Remove service panel front 2x screws.
3. Remove service panel rear 2x screws; Lift panel out carefully and put to one side (leaving the
CAT5 cable connected to control panel receiver).
4. Remove log set if installed.
5. Remove burner cover.
Burner assembly
Burner Cover
Comments
1.70mm
For Vertical Flues ONLY
Pilot head
Advertisement
Table of Contents
