Exmark RADIUS Operation Manual page 45

A B
C D
F
E
g027477
Figure 39
Note: Ensure the oil filter gasket touches the
engine, then an extra 3/4 turn is completed.
Note: Dispose of the used oil at a recycling
center.
6. Slowly pour approximately 80% of the specified
oil into the filler tube—use oil recommended in
the Checking the Engine Oil Level–Exmark
708cc Engine section.
A
C
3/4
7. Check the oil level; refer to Checking the
Engine Oil Level–Exmark 708cc Engine
section.
8. Start the engine and check for leaks.
Changing the Engine Oil-Kohler
Engine
Service Interval: After the first 5 hours
1. Park the machine so that the drain side is slightly
lower than the opposite side to ensure the oil
drains completely.
2. Start the engine and let it run until warm. This
warms the oil so it drains better.
3. Disengage the blade control switch and ensure
the parking brake is engaged.
4. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
45
B
D
F
E
Figure 40
Every 100 hours (change
it more often under a
heavy load or in high
temperatures) (Kohler
Engine).
Maintenance
g027484