High Limit Replacement; Door Gasket Replacement; Relay Replacement - Henny Penny HC-903 Service Manual

HIGH LIMIT REPLACEMENT

Tools: Phillips screwdriver
1. Disconnect the electrical supply to the
cabinet.
WARNING: Place the power switch in
the OFF position and unplug the power
cord. Failure to do so could result in
electrical shock.
2. Remove the access panel from the top
of the cabinet.
3. Remove the wires attached to the high
limit.
4. Remove the two screws that hold the
high limit to the heater and remove high
limit..
5. Install the new high limit in reverse
order.

DOOR GASKET REPLACEMENT

tools: Phillips screwdriver
1. Pull the gasket to the side to expose the
screws that hold the retainer to the cabinet.
2. Loosen the screws around the full outside
perimeter of the gasket.
3. With screws loose, the gasket should slide
out from under the retainer.
4. Install new gasket in reverse order.

RELAY REPLACEMENT

Tools: 5/16" (8 mm) socket or wrench
1. Disconnect the electrical supply to the
cabinet.
WARNING: Place the power switch in the
OFF position and unplug the power cord.
Failure to do so could result in electrical
shock.
2. Remove the screws to the control panel.
19