Configuring Etherchannels - Cisco Catalyst 2928 Software Configuration Manual

Configuring EtherChannels

Figure 32-3
Configuring EtherChannels
•
•
•
•
•
•
Note Make sure that the ports are correctly configured. For more information, see the
Configuration Guidelines" section on page
After you configure an EtherChannel, configuration changes applied to the port-channel interface apply
Note
to all the physical ports assigned to the port-channel interface, and configuration changes applied to the
physical port affect only the port where you apply the configuration.
Catalyst 2928 Switch Software Configuration Guide
32-8
Load Distribution and Forwarding Methods
Switch with
source-based
forwarding enabled
EtherChannel
Cisco router
with destination-based
forwarding enabled
Default EtherChannel Configuration, page 32-9
EtherChannel Configuration Guidelines, page 32-9
Configuring Layer 2 EtherChannels, page 32-10
Configuring EtherChannel Load Balancing, page 32-12
Configuring the PAgP Learn Method and Priority, page 32-13
Configuring LACP Hot-Standby Ports, page 32-14
Chapter 32
(required)
(optional)
(optional)
(optional)
32-9.
Configuring EtherChannels
"EtherChannel
OL-23389-01