Table of Contents
Advertisement
Configuring the Switch SDM Template
The rows in the tables represent approximate hardware boundaries set when a template is selected. If a
section of a hardware resource is full, all processing overflow is sent to the CPU, seriously impacting
switch performance.
Configuring the Switch SDM Template
These sections contain this configuration information:
•
•
•
Default SDM Template
The default template is the default.
SDM Template Configuration Guidelines
When you select and configure SDM templates, you must reload the switch for the configuration to take
effect.
•
Beginning in privileged EXEC mode, follow these steps to use the SDM template to maximize feature
usage:
Command
Step 1
configure terminal
Step 2
sdm prefer {default | qos}
Step 3
end
Step 4
reload
After the system reboots, you can use the show sdm prefer privileged EXEC command to verify the new
template configuration. If you enter the show sdm prefer command before you enter the reload
privileged EXEC command, the show sdm prefer command shows the template currently in use and the
template that will become active after a reload.
Catalyst 2928 Switch Software Configuration Guide
6-2
Default SDM Template, page 6-2
SDM Template Configuration Guidelines, page 6-2
•Setting the SDM Template, page 6-2
Setting the SDM Template
Purpose
Enter global configuration mode.
Specify the SDM template to be used on the switch:
The keywords have these meanings:
default—Gives balance to all functions.
•
qos—Maximizes system resources for QoS ACEs.
•
Use the no sdm prefer command to set the switch to the default
template.
The default template balances the use of system resources.
Return to privileged EXEC mode.
Reload the operating system.
Chapter 6
Configuring SDM Templates
OL-23389-01
Advertisement
Table of Contents
Troubleshooting
