Dip Switches; Figure 3-4 Dip Switches - P-Com AirPro Gold Hardware Installation Manual

D I P S W I T C H E S
•
•
1
2
Hardware Installation Guide
• RF channel—all units in a common network must use the same RF
channel. Separate WANs in the same geographic area may need to
use different channels (to eliminate interference). AirPro Gold
provides 13 channels.
• Topology—AirPro Gold provides these topologies: peer-to-peer,
point-to-point, centralized (star base and star remote)
• Configuration Reset—to install the basic configuration
You can set up a basic radio configuration using one of three methods:
• through DIP switch positions
• through a terminal command line interface
• through the Site Manager software application
AirPro Gold can be configured through a block of twelve OFF/ON DIP
switches located on the front of the unit behind the switch plate. See
Figure 3-4.
S W I T C H E S M U S T B E O F F
T O C O N F I G U R E B Y S O F T W A R E O R T E R M I N A L A L L 1 2
B I N A R Y F O R M A T ( 1 - O N , 0 - O F F )
R F C H A N N E L M U S T B E S E L E C T E D U S I N G
O F F O F F P O I N T - T O - P O I N T
O F F O N P E E R - T O - P E E R
O N O F F S T A R B A S E
O N O N S T A R R E M O T E
1 2 3 4 5 6 7 8
9 1 0
T O P O L O G Y
O
2 1
8 4 8
N
RF CHANNEL
1 2

Figure 3-4 DIP Switches

To set the switch to the ON position, push the switch up toward the top of the
unit.
To set the switch to the OFF position, push the switch down toward the bottom
of the unit.
To set up a basic unit configuration using the DIP switches:
Remove the unit from the shipping carton.
Place the unit on a flat surface so that the front is easy to reach.
H A R D W A R E I N S T A L L A T I O N
Basic Configuration Setup
9 10 11 12
ON-CONFIGURATION RESET
ON-ANTENNA ALIGNMENT
2 1
4
MODE
OFF-NORMAL MODE
SEE COVER LABEL
3 4 5 6 7 8 9 10 11 12
APG2_022
3-5