Lan Connection; Antenna Connection; Figure 3-1 Ground Wire On Airpro Gold Unit - P-Com AirPro Gold Hardware Installation Manual

H A R D W A R E I N S T A L L A T I O N
3
Wireless Router Installation
1
2
L A N C O N N E C T I O N
1
2
NOTE
✐
A N T E N N A C O N N E C T I O N
3-2
To ground the AirPro Gold unit:
Loosen the GND nut on the back of the unit.
Attach a #12 AWG minimum wire from the grounding stud to a safe ground.
See Figure 3-1 on page 3-2.

Figure 3-1 Ground Wire on AirPro Gold Unit

To connect the AirPro Gold to the LAN:
Plug one end of an RJ-45 cable into the RJ-45 ETHERNET port on the front of
the unit.
Plug the other end of the RJ-45 cable into the RJ-45 port on the Ethernet Hub.
If you are connecting the unit directly to a PC via the RJ-45 port, use a cross-
over cable (not a straight-through cable), plug one end into the RJ-45 port on
the AirPro Gold unit and the other end into the RJ-45 port of the Ethernet card
on the PC.
The type of antenna you use should be a semi-parabolic or solid
parabolic directional antenna. You can purchase the antenna from P-
Com or its distributors.
100–240 V ~
0.5–0.2A
50/60 Hz
GND
Ground Wire
A P G 2 _ 0 1 3
P-Com AirPro Gold