Table of Contents
Advertisement
Clock/Timer
Timer setting
The system can switch on to CD or TUNER
mode automatically at a preset time, serving as
an alarm to wake you up.
IMPORTANT!
– Before setting the timer, ensure that the
clock is set correctly.
– The timer will always be switched on
after it has been set.
– The timer will not start if a recording is in
progress.
– The volume of the timer will increase
gradually from the minimum level to the
last tuned volume level.
1
Press and hold CLOCK•TIMER for more than
two seconds to select timer mode.
➜
The last timer setting starts flashing.
➜
starts flashing.
TIMER
➜
The selected source will be lighted and
flashing.
2
Press CD or TUNER to select the desired
source.
●
Before setting timer, make sure the music source
has been prepared.
CD – Load the disc(s). To start from a specific
track, make a programme (refer to "CD
Operation - Programming the disc tracks").
TUNER – tune to the desired radio station.
3
Press ALBUM-/+à á on the system
repeatedly to set the hour for the timer to start.
4
Press TITLE-/+í/ë on the system
repeatedly to set the minute for the timer to
start.
5
Press CLOCK•TIMER to store the start time.
➜
remains on the display.
TIMER
●
At the preset time, the selected source will play.
To exit without storing the setting
●
Press STOP Ç on the system.
Notes:
– When the preset time is reached and the
selected disc tray is empty, the next available disc
will be selected. If all the disc trays are not
available, Tuner will be selected automatically.
– During timer setting, if no button is pressed
within 90 seconds, the system will exit timer setting
mode automatically.
28
To deactivate the TIMER
●
Press TIMER ON/OFF on the remote control.
➜
The display will show "OFF" and
disappear from the display.
To activate the TIMER
●
Press TIMER ON/OFF on the remote control.
➜
The last set timer information will be shown
for a few seconds and
display.
Sleep timer setting
The sleep timer enables the system to switch to
standby mode automatically at a preset time.
1
Press SLEEP on the remote control repeatedly
to select a preset time.
➜
The selections are as follows (time in
minutes):
15 ™ 30 ™ 45 ™ 60 ™ OFF ™ 15 ...
➜
"SLEEP XX" or "OFF" is displayed. "XX" is
the time in minutes.
2
When you reach the desired length of time, stop
pressing the SLEEP button.
➜
is shown, except for "OFF" mode.
SLEEP
➜
The sleep timer is now set. Before the system
switches to standby mode, a countdown of 10
seconds is displayed.
"SLEEP 10" ™ "SLEEP 9".... ™ "SLEEP 1"
™ "SLEEP"
To check the remaining length of time
after sleep timer is activated
●
Press SLEEP once.
To change the preset sleep timer
●
Press SLEEP again while the remaining sleep
timer is shown.
➜
The display will show the next sleep timer
options.
To deactivate the sleep timer
●
Press SLEEP repeatedly until "OFF" is displayed,
or press STANDBY -ON/ECO POWER
(2) .
will
TIMER
will appear on the
TIMER
Hide quick links:
Advertisement
Table of Contents
