Basic Functions; Plug And Play - Philips FWM575/37B User Manual

Basic Functions

IMPORTANT!
Before you operate the system, complete
the preparation procedures.

Plug and Play

Plug and Play allows you to store all available
radio stations automatically.
First time setup/power up
1
When you turn on the main supply, "AUTO
INSTALL - PRESS PLAY" is displayed.
2
PressÉ Å on the system to start installation.
➜ "PLUG AND PLAY" .... "INSTALL" is
displayed, followed by "TUNER" and "AUTO".
➜
starts flashing.
PROG
➜
All available radio stations with sufficient
signal strength will be stored automatically,
starting from FM and followed by AM band.
➜
When all the available radio stations are
stored or the memory for 40 presets are used,
the last preset radio station will be played.
14
(for tuner installlation)
To reinstall Plug and Play
1
In standby or demonstration mode, press and
holdÉ Å on the system until "AUTO INSTALL
- PRESS PLAY" is displayed.
2
PressÉ Å again to start installation.
➜
All previously stored radio stations will be
replaced.
To exit without storing the Plug and Play
●
Press Çon the system.
➜
If you do not complete the Plug and Play
installation, the function will be restarted when
you next turn on the main supply again.
Notes:
– When the power is turned on, the disc tray may
open and close to initialise the system.
– If no stereo frequency is detected during Plug
and Play, "CHECK ANTENNA" will be displayed.
– During Plug and Play, if no button is pressed
within 15 seconds, the system will exit Plug and
Play mode.