Kenwood KDC-300UVM Instruction Manual page 18

Installing the unit (in-dash mounting)
When installing without the mounting sleeve
1
Remove the mounting sleeve and trim plate from the unit.
2
Align the holes in the unit (on both sides) with the vehicle
mounting bracket and secure the unit with screws (supplied).
Use only the specified screws. Using wrong screws might damage the unit.
18
Hook on the top side
Orientate the trim plate as
illustrated before fitting.
How to remove the unit
1
2
3
Dashboard of your car
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
Detach the faceplate.
Fit the catch pin on the extraction keys into the holes on both
sides of the trim plate, then pull it out.
Insert the extraction keys deeply into the slots on each side,
then follow the arrows as shown below.
Do the required wiring.
( 19)