Hardware Installation; System Requirements - NETGEAR WNR612 User Manual

Netgear WNR612 Wireless Router User Manual
The third RJ45 interface is WAN interface, for connecting
WAN or the uplink network devices.
Reset button. Press this button for 3 seconds and then release
it, and then the wireless router reboots and restores to the
factory defaults.
Power socket, for connecting the power adapter (5V DC,1A).
Power switch
Caution:
Do not press Reset unless you want to clear the current settings. The
Reset button is in a small circular hole on the rear panel. If you want to
restore the default settings, please press the Reset button gently for 3
seconds with a fine needle inserted into the hole and then release the
button. The system reboots and restores to the factory default settings.
The power specification is 5V DC, 1A. If the power adapter does not match
the specification, the device may be damaged.
3.3

Hardware Installation

3.3.1 System Requirements

Before installing the device, please ensure that the following items are ready:
At least one Ethernet RJ45 cable (10Base-T/100Base-T)
One NETGEAR WNR612 wireless router
A PC is already installed with the TCP/IP protocol and the PC can access the
Internet.
7