Basic Functions; Plug And Play; Demonstration Mode - Philips FW C798 User Manual

FW- MINI HIFI SYSTEM
STANDBY-ON
ECO POWER
DISPLAY
DEMO
PLAY•
STOP/
PAUSE
CLEAR
IMPORTANT!
Before you operate the system, complete
the preparation procedures.

Plug and Play

Plug and Play allows you to store all available
radio stations automatically.
If Plug and Play has not been installed
1
When you turn on the system, "AUTO
INSTALL - PRESS PLAY" will be displayed.
2
Press PLAYÉ on the system to start
installation.
"INSTALL" will be displayed and followed by
"TUNER" and then "AUTO".
will start flashing.
PROG
The system will search for all radio stations
on the FM band, then the AM band.
All available radio stations with sufficient signal
strength will be stored automatically.
The system will stop searching when all the
available radio stations are stored or when the
memory for 40 preset radio stations is used.
The last preset radio station will play when
Plug and Play is completed.
To reinstall Plug and Play
1
In Standby or Demonstration mode, press and
hold PLAYÉ on the system until "AUTO
INSTALL - PRESS PLAY" is displayed.
2
Press PLAYÉ again to start installation.
All previously stored radio stations will be
replaced.
pg 001-032/C798/37-Eng
MUSIC LEVEL VOLUME
INTERACTIVE VU METER
CLOCK• AUTO
PROG TIMER REPLAY DUBBING REC
CD 1•2•3 FM •AM
CD TUNER
SOURCE
WOOX
ON • OFF LEVEL
TAPE AUX W OO X
DYNAMIC
AMPLIFICATION
CONTROL
TAPE 1•2 CDR / DVD
15

Basic Functions

VOLUME
ATION - JOG
To exit without storing the Plug and Play
Press Çon the system.
Notes:
– When the power is turned on, the disc tray may
open and close to initialize the system.
– If you do not complete Plug and Play installation,
Plug and Play will be reinitiated the next time you
turn on the power.
– If no stereo frequency is detected during
Plug and Play, "CHECK ANTENNA" will be
displayed.
– During Plug and Play, if no button is pressed
within 15 seconds, the system will exit Plug and
Play mode automatically.

Demonstration mode

The system has a demonstration mode that
shows the various features offered by the system.
To activate the demonstration
In Standby mode, press and hold DEMO
STOPÇon the system until "DEMO ON" is
displayed.
The demonstration will begin.
To deactivate the demonstration
Press and hold DEMO STOP Çon the system
until "DEMO OFF" is displayed.
The system will switch to Standby mode.
Note:
– Even if you remove the AC power cord and
reconnect it to the wall socket, the demonstration
will remain off until you activate it again.
4/16/02, 6:39 PM
15
3139 115 21261