Dealing With Problems; (Advanced) - Panasonic CF-07 Series Reference Manual

Dealing with Problems (Advanced)
When a problem occurs, power off the wireless display, then connect the optional port replicator (CF-VEB071), external
keyboard and external display, and then refer to this page. If you still cannot troubleshoot the problem, contact Panasonic
Technical Support.
Starting Up
The power indicator or
battery indicator is not lit
[Enter Password] is dis-
played
POST Startup Error(s) is
displayed
Windows startup, or an
operation is extremely
slow
The date and time are in-
correct
The cursor cannot be
controlled
When resuming from the
standby or hibernation
mode, [Enter Password]
does not appear even if
a password has been set
in the Setup Utility
The DISPLAY READY in-
dicator does not go on
even when the HDD indi-
cator goes off
When the administrator
password is forgotten
When the previous item
is not the cause
Check the cable connection for the AC adaptor.
Check to see if a fully charged battery is properly installed.
Remove the battery pack and disconnect the AC adaptor, then connect them again.
Input your password. If you have forgotten it, contact Panasonic Technical Support.
page 36
Press F9 in the Setup Utility (
settings to their default values (except the password settings). Then, the Setup Utility
must be run once again for you to input the appropriate operating environment set-
tings. (The processing speed depends on the application software used, so this
operation may not cause the processing speed to increase.)
You can set the date and time through [Control Panel] - [Date, Time, Language,
and Regional Options] - [Date and Time].
When the computer is connected to a LAN, confirm the date and time of the server.
If you continue to experience problems, the internal battery maintaining the clock
may need to be replaced. Contact Panasonic Technical Support.
This computer will not correctly recognize the date and time starting from the year
2100 A.D.
Restart the computer by using the keyboard (e.g., Ctrl + Esc ,
When the port replicator is not connected, turn off the computer.
Even when a password has been set in the Setup Utility, [Enter Password] does
not appear when the computer resumes from the standby or hibernation mode.
If you want to use the security function when using the standby or hibernation
mode, use the Windows password as follows:
Select the account to change in [Control Panel] - [User Accounts] and set the
password, then add the check mark for [Prompt for password when computer re-
sumes from standby] in [Control Panel] - [Performance and Maintenance] - [Power
Options] - [Advanced].
Press the MENU button of the wireless display, then set the password (
ing Instructions of the wireless display).
A problem possibly occurred during startup.
After powering off the computer, connect the port replicator and restart the computer.
If you have created a password reset disk (
sage is displayed when you fail to correctly enter the password. Follow the message's
instructions and set the password again by using the password reset disk.
If you have not created a password reset disk, after reinstalling, setup Windows and
then set the password again.
Press F9 in the Setup Utility (
settings to their default values (except the password settings).
Try removing all peripheral devices.
Check a disk error using the following procedure.
1 Select [Local Disk (C:)] with the right button in [Start] - [My Computer], and select
[Properties].
2 Select [Tools] - [Check Now].
3 Select [Start] after selecting required items in [Check disk options].
At start-up, press F8
page 28). This will restore the Setup Utility's
"First-time Operation"), a mes-
page 28). This will restore the Setup Utility's
to operate the computer in the Safe mode.
38
or ).
Operat-