Connecting Antennas; Connecting The Control Cable; Connecting A Tv; Connecting The Power Cord - Philips - MCD700 User Manual

Connections

Connecting antennas

Connect the supplied AM antenna and FM
antenna to the respective terminals. Adjust the
position of the antenna for optimal reception.
AM Indoor Antenna
1
●
Position the antenna as far as possible from a TV,
VCR or other radiation source.
FM Indoor Antenna
●
For better FM stereo reception, connect an
outdoor FM antenna to the FM AERIAL (FM
ANTENNA) terminal.

Connecting the control cable

Connect the serial port marked "CONTROL
CABLE" at the rear of the DVD player to the
same port at the rear of the power amplifier
with the supplied flat control cable.

Connecting a TV

You must connect a TV to your DVD micro
system in order to view the DVD/VCD playback.
12
2
IMPORTANT!
– There are various ways to connect the
system to a TV. You only need to make
one of the best connections, depending
on the capabilities of your TV system.
– If COMPOMENT video output jacks
or S-Video jack is used for video
connection, the system's Component
setting will need to be set accordingly.
Details are shown under "Video Setup
Page".
●
Connect the VIDEO OUTPUT jack to the
video input jack on the TV using a video cable
(yellow).
OR
Option 1
Connect the S-VIDEO output jack to the S-
Video input jack on the TV using an S-Video
cable (not supplied).
OR
Option 2
Use the component video cables (red/blue/
green) to connect the DVD micro system's
COMPONENT video output jacks to the
corresponding component video input jacks (or
labeled as Pr/Cr Pb/Cb Y or YUV) on the TV.
IMPORTANT!
– The progressive scan video quality is
only possible when using Y Pb Pr and a
progressive scan TV is required. (Proceed
to page 17-18 for detailed Progressive
Scan setup.)
Option 1
Note:
– To avoid magnetic interference, do not position
the front speakers too close to your TV.
Option 2