Fluke 123B User Manual page 64

123B/124B/125B
Users Manual
7. Use YZWX and  to set the time.
Events are used to determine how often a waveform
deviates from the initial waveform when recording
starts. It is easy to see the time of a deviation when
you view the recording after it stops.
YZ
8. Use to highlight Threshold.
9. Push  and use YZ and  to set the
percentage of deviation for time (relative to 1 period)
and the amplitude deviation (relative to peak-to-peak)
for waveforms. Threshold can be used for signals up
to 10 kHz.
10. Use YZ to highlight the memory type for recording
as either the internal memory of the Test Tool or an
SD memory card.
11. Push  to accept the memory location.
12. Push 4 when done.
54
hxv39.eps
13. To start or stop a recording, push  or 4.
The Test Tool continuously logs all data to memory.
While recording, the display does not update since all
the processing capacity is needed for recording.
The Test Tool beeps when an event occurs.
Note
hxv42.eps